WARNING: CHOKING HAZARD. NOT A TOY. DO NOT LEAVE WITH CHILDREN OR PETS. USE CAUTION WHEN USING HEAT. SELLER ASSUMES NO LIABILITY FOR INJURIES OR DAMAGE RESULTING FROM THESE INSTRUCTIONS.
1: TEST (NO MASK)
The clip should rest easily on the nose without any discomfort.
There should be absolutely no gap between the plastic and the nose or cheeks.
If the clip is uncomfortable or if any gaps are present, the clip requires adjustment, otherwise the clip will provide unsatisfactory results. See Step 2.
However, if the clip conforms perfectly to the nose/cheeks, and is comfortable, skip to Step 3
2: ADJUST
Microwave 1 cup (250ml) water for 60-90 sec *May require longer/shorter duration.
Stir clip in hot water for 3-5 sec, repeating until clip is slightly flexible. *Reheat water if required.
Ensure slots are facing down, then gently shape plastic and remove all gaps between nose/cheeks and clip. *Do not force – reheat if necessary.
Once the clip is comfortable and gaps are eliminated, proceed to Step 3.
3: INSTALL
Work the inside of the clip onto the fabric at an angle. Use a butterknife to gently pry slots open for thicker materials.
Work clip back and forth with downward pressure until secure.
Repeat steps above on opposite side of mask.
Tighten any loose material while centering clip on mask.
Need help?
Review the online demo installation video above
Try raising and lowering the clip to test different positions on the nose.
Check that all possible gapsbetween the skin and clip have been eliminated. Re-adjust if necessary.
Ensure the mask is not loose fitting – the clip requires some light pressure against the skin to block the air flow.